Component Solution Services REC02F Manuel de service télécharger pdf (Page 85)

Ultraview 1030/1050 Monitors — Service Manual

4-21

Maintenance

3 Remove the six jackscrews and the knurled nuts (two each) not shown. The knurled nuts are

located on the audio jacks and require a special tool for removal (P/N 003-0117-xx).

Figure 4-14: Removing the I/O bay PCBA

4 Remove the three 6-32 × 1/4 inch screws holding the I/O bay PCBA.

Removing the Gas Interface PCBA for Option G

Figure 4-15: PCBA support plate and gas interface PCBA for option G

1 Remove four each 6-32 × 1/4 inch screws holding the support plate to access the gas interface

PCBA assembly.

2 Remove the label directly over the assembly on the outside of the case.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 141 142

Pas de commentaire

Component Solution Services REC02F Manuel de service Page 85